Hot Spring Ace Salt Cell Cleaner

Hot Springs Ace Cell Cleaner

Features

• Ace cell cleaner is used to clean the Salt Cell of the Hot Spring ace salt water system

Instructions:

1. Power off the hot tub by turning off the beakers at the electrical subpanel box near the hot tub.  The ACE Salt Cell should not be removed from water or placed into the Cell Cleaner product unless power is turned off to the hot tub.
2. Remove the ACE Cell from the hot tub.
   • Open the hot tub cover
   • Remove the filter lid
   • Unthread the gray cap which the white cord of the ACE Cell passes through
   • Gently lift the ACE Cell out of the gray standpipe
3. Clean the ACE Cell
   • Place Cell Cleaner on solid surface near ACE Cell.  The spa step is a good place to work.
   • Carefully place ACE Cell in the Cell Cleaner solution bottle
   • Let ACE Cell Soak until no more bubbles are coming from the ACE Cell and for at least 10 minutes and no more than 12 hours.  NOTE: Close spa cover whenever leaving the hot tub unattended during cleaning.
   • Remove ACE Cell from Cell Cleaner bottle making sure not to spill or drip any of the cell cleaner solution.  NOTE: Rinse any drips or spills of the cell cleaner solution immediately to prevent damage or harm.
   • Rinse the ACE Cell in with water
   • Inspect the ACE Cell for any visible scale build up or damage.  Repeat cleaning as necessary.
   •  
4. Install ACE Cell in the filter standpipe
1. Insert into the gray filter standpipe
2. Screw on gray cap
3. Replace filter lid
5. Power on the hot tub according instructions in the Owner's Manual
6. Properly dispose of the Cell Cleaner using the disposal instructions below 

The Vanishing Act hardness remover will help keep calcium harness levels low